Medical and Dental Consultants’ Association of Nigeria
Home - About us - Editorial board - Search - Ahead of print - Current issue - Archives - Submit article - Instructions - Subscribe - Advertise - Contacts - Login 
  Users Online: 1298   Home Print this page Email this page Small font sizeDefault font sizeIncrease font size
 
ORIGINAL ARTICLE
Year : 2016  |  Volume : 19  |  Issue : 2  |  Page : 218-222

Influence of different surface treatments on push-out bond strengths of fiber-reinforced posts luted with dual-cure resin cement


1 Department of Endodontics, Faculty of Dentistry, Ataturk University, Erzurum 25040, Turkey
2 Department of Prosthodontics, Faculty of Dentistry, Ataturk University, Erzurum 25040, Turkey
3 Department of Endodontics, Faculty of Dentistry, Erciyes University, Kayseri 38039, Turkey
4 Department of Restorative Dentistry, Faculty of Dentistry, Akdeniz University, Antalya 07058, Turkey

Correspondence Address:
L B Ayranci
Department of Endodontics, Faculty of Dentistry, Atatürk University, Erzurum 25240
Turkey
Login to access the Email id

Source of Support: None, Conflict of Interest: None


DOI: 10.4103/1119-3077.175962

Rights and Permissions

Objectives: The objective was to evaluate whether fiber postsurface conditioning with air abrasion or erbium:yttrium-aluminum-garnet (Er:YAG) laser would influence the bond strength of dual-cure resin cement to the fiber-reinforced (FRC) posts. Materials and Methods: Twenty-one FRC posts were divided into three groups according to surface treatment methods as follows: An untreated control group air abrasion with Al2O3group, and Er:YAG laser treated group with 150 mJ parameter. Fiber posts were then built up to dual-cure resin cement. Eighteen specimens were set and sectioned perpendicularly along the long axis of the post using a saw. Two disks (thickness of 2 mm) were obtained from each specimen (n = 12). Remaining three posts were stored for scanning electron microscopic evaluation. Push out test was performed on the each specimen and the values were recorded as MPa. The data were analyzed using one-way analysis of variance and Tukey post-hoc tests (P < 0.05). Results: The bond strength values for the groups were as follows: Control (15, 28 MPa), air abrasion group (19, 73 MPa), and Er:YAG group (17, 84 MPa). Air abrasion affected the bond strength significantly (P < 0.05). Conclusion: Air abrasion attained higher bond strengths when FRC posts were luted to dual-cure resin cement. Additional studies should be designed with different types and parameters of laser devices to understand the effect of these devices on bond strength.


[FULL TEXT] [PDF]*
Print this article     Email this article
 Next article
 Previous article
 Table of Contents

 Similar in PUBMED
   Search Pubmed for
   Search in Google Scholar for
 Related articles
 Citation Manager
 Access Statistics
 Reader Comments
 Email Alert *
 Add to My List *
 * Requires registration (Free)
 

 Article Access Statistics
    Viewed1419    
    Printed22    
    Emailed0    
    PDF Downloaded327    
    Comments [Add]    
    Cited by others 1    

Recommend this journal