Medical and Dental Consultantsí Association of Nigeria
Home - About us - Editorial board - Search - Ahead of print - Current issue - Archives - Submit article - Instructions - Subscribe - Advertise - Contacts - Login 
  Users Online: 845   Home Print this page Email this page Small font sizeDefault font sizeIncrease font size
 
ORIGINAL ARTICLE
Year : 2020  |  Volume : 23  |  Issue : 6  |  Page : 792-797

Shear bond strength of zirconia ceramic to the primary tooth dentin


1 Department of Pediatric Dentistry, University of Eskisehir Osmangazi, Eskisehir, 26480, Turkey
2 Department of Prosthodontics, Faculty of Dentistry, University of Eskisehir Osmangazi, Eskisehir, 26480, Turkey

Correspondence Address:
Dr. N Tuloglu
Department of Pediatric Dentistry, Faculty of Dentistry, Eskisehir Osmangazi University, 26480, Eskisehir
Turkey
Login to access the Email id

Source of Support: None, Conflict of Interest: None


DOI: 10.4103/njcp.njcp_567_19

Rights and Permissions

Background: There is no information about the shear bond strengths (SBS) of zirconia ceramic to primary tooth dentin. Aim: To investigate the effect of different surface treatments and cements on the shear bond strength (SBS) of zirconia ceramic to primary tooth dentin. Materials and Methods: Prepared zirconia bars were distributed into four groups according to surface treatment procedure: control, sandblasting, CoJet and hot etching. The zirconia specimens in each group were further divided into subgroups according to cement (n = 13): self-adhesive resin (Rely-X Unicem), resin-modified glass ionomer (Ketac-Cem Plus), and universal bioactive (BioCem). Zirconia specimens were bonded to the primary tooth dentin surface by cement. SBS was measured, and the data were subjected to two-way ANOVA and Tukey's tests. Results: Statistical differences were observed in the surface treatment procedures for Rely-X Unicem (P < 0.05), but no statistically significant differences were found in the sandblasting, CoJet and hot-etching groups for Ketac-Cem Plus (P > 0.05). For BioCem, the SBS value for the hot etching group was significantly lower than those for the CoJet and sandblasting groups (P < 0.05). The SBS values for the Rely-X Unicem subgroups (sandblasting, CoJet and hot etching) were significantly higher than those for the other cements (P < 0.05). Conclusion: The bond strength of zirconia ceramic to primary tooth dentin is affected by surface treatments and cements.


[FULL TEXT] [PDF]*
Print this article     Email this article
 Next article
 Previous article
 Table of Contents

 Similar in PUBMED
   Search Pubmed for
   Search in Google Scholar for
 Related articles
 Citation Manager
 Access Statistics
 Reader Comments
 Email Alert *
 Add to My List *
 * Requires registration (Free)
 

 Article Access Statistics
    Viewed124    
    Printed0    
    Emailed0    
    PDF Downloaded60    
    Comments [Add]    

Recommend this journal